Point cloud display after coordinate conversion is rough and does not display properly.

Issue

After converting coordinates, it should be seen the converted point cloud in the "Point Cloud (After Coordinate Conversion)" tab, but the point cloud is significantly rough and not displayed properly.

Answer

In the following cases, the point cloud after coordinate transformation becomes extremely rough.

1. Wrong setting of the target point at the time of coordinate conversion.
2. Significant deviation of measured values.

Explanation

1. If the fixed points are not selected and set correctly during the coordinate conversion, it will not be successful and the converted point cloud will be displayed roughly. Please check that the selected points are correct.
2. If the shooting method is inappropriate, the LiDAR point cloud will not be created properly, and large deviations will occur during coordinate conversion.